FixVault
Home › Chrysler › 2005 › PT Cruiser Base, 2D Convertible, Automatic › Repair and Diagnosis › External Pages › Different car › Section 205 (Ignition Control) › Glow Plug › Installation

Glow Plug: Installation

WARNING: This page is about a different car, the 2005 Jeep Liberty. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install glow plugs all the way into cylinder head, hand tight, until the thread stops. See Figure.
  2. Tighten glow plugs to 12.5 N.m (110 in.lbs.).
  3. Connect glow plug electrical connectors. See Figure.
  4. Install intake manifold air inlet tube. See Figure.
  5. Install generator (Refer to ELECTRICAL/CHARGING/GENERATOR - INSTALLATION) .
  6. Connect negative battery cable.
About FixVault