FixVault
Home › Chrysler › 2005 › Sebring Base, 2D Coupe › Repair and Diagnosis › External Pages › Different variant/trim › Section 29 (Electronic Control Modules - Except Coupe) › Heated Seat Module › Removal

Heated Seat Module: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Move the appropriate power seat track to its uppermost and rearward-most stop position.
  2. Disconnect and isolate the negative battery cable.
  3. Reach under the front of the seat cushion and separate the heated seat module from the seat cushion frame. See Figure.
  4. Disconnect the wire harness connector from the connector receptacle on the back of the heated seat module.
  5. Remove the heated seat module from the vehicle.
About FixVault