Spring Clamp Plates: Removal
WARNING: This page is about a different car, the 2006 Dodge Sprinter. However, it is still accessible from the selected car via links, so may be relevant.
- Raise and support the vehicle.
- Install a jack under the lower ball joint and lower the weight of the vehicle enough to allow a wrench between the lower control arm and the bracket tighten the nut.
- Remove the front and rear bolts to the spring clamp plates.
- Remove the four inner retaining bolts and nuts.
- Remove the spring clamp plate and rubber block.
- Remove the shear bushings from the front and rear bolts.