FixVault
Home › Chrysler › 2006 › PT Cruiser Base, 2D Convertible, Standard › Repair and Diagnosis › Restraints › Restraints Control Systems › Restraints System (Service Information) › Front Seat Belt And Retractor › Removal

Front Seat Belt And Retractor: Removal

WARNING: Front seat belt assemblies must be replaced after a collision.
  1. Disconnect and isolate the battery negative cable.
  2. Wait two minutes for the system reserve capacitor to discharge before servicing any airbag components.
  3. Remove plastic turning loop cover.
  4. Remove shoulder belt height control knob.
  5. Remove bolt attaching turning loop to belt adjuster.
  6. Remove upper B-pillar trim (Refer to BODY/INTERIOR/B-PILLAR TRIM - REMOVAL) .
  7. Remove access cover from B-pillar trim.
  8. Remove anchor bolt from lower B-pillar.
  9. Disengage clips attaching trim to B-pillar.
  10. Feed seat belt turning loop and seat belt through trim panel.
  11. Disconnect electrical connector.
  12. Remove the webbing mid guide two screws.
  13. Remove lower B-pillar trim from vehicle.
  14. Remove front seat belt retractor.
About FixVault