Power Liftgate System: Chime/Thermistor: Installation
- Snap the chime/thermistor assembly into the light bar.
- Locate the wires going to the chime/thermistor. Install the wires in the connector. Secure with a tie strap. Refer to WIRING DIAGRAM INFORMATION
for detailed instructions.
NOTE:
Be certain the wires are reinstalled in the correct wire cavities. Failure to do so could result in damage to the chime/thermistor assembly. Refer to SYSTEM WIRING DIAGRAMS
if uncertain.
- Install the rear light bar assembly on the vehicle. Refer to INTERIOR/EXTERIOR
for the procedure.
- Connect the negative battery cable.