Customer Normal Operating Mode
WARNING: This page is about a different car, the 2006 Dodge Viper. However, it is still accessible from the selected car via links, so may be relevant.
The customer starts the battery save feature by doing the following:
- Insert key into ignition switch.
- Cycle the ignition switch from Off to Accessory four times without going into RUN.
- Leave the switch in the OFF position after the fourth cycle without removing the key. This puts the BCM into the learn mode.
- The customer then depresses the driver's side Power Door Lock switch in the UP direction.
- A horn chirp will tell the customer that the process has begun.
- All interior and exterior lights (if on) will be turned off.
- Key may be removed or left in at this point.
- VTSS may be armed before Sleep Mode by using the RKE or the door lock switch.
The customer can exit battery save mode by doing the following:
- Press the Driver door outside handle (this will wakeup the vehicle).
- If the door did not open, then the vehicle must be locked-press the RKE Unlock.
- Press the Driver door outside handle.
- Cycle the ignition key to RUN-this will cancel the feature.
- If the ignition is not cycled to RUN, then the BCM will re-enter Sleep Mode 30 seconds after the last door is closed.