Ignition Coil: Installation: Notes

WARNING: This page is about a different car, the 2006 Chrysler Crossfire. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Removing/Connecting Ignition Coil From Cylinder Head Cover

Courtesy of DAIMLERCHRYSLER CORP.

Position the ignition coil (3) on the cylinder head cover.
Install the ignition coil retaining bolt (2). Tighten the bolt to 8 N.m (71 in. lbs.).
Connect the ignition coil wire harness connector (1) to the coil pack.

Fig 2: Firing Plugs Operation
Courtesy of DAIMLERCHRYSLER CORP.

NOTE: When installing the spark plug cables, route the cables correctly. Failure to route the cables properly can cause improper spark plug phase-shift.
Install the spark plug cables to the appropriate coil tower (A & B) (coil side).
Install the spark plug cables to the appropriate spark plug location (G & K) (plug side).
NOTE: Refer to the reference pad cast into the cylinder head cover to identify proper spark plug/spark plug cable orientation.

Fig 3: Insuring Firm Connection Is Made From Spark Plug Cables To Spark Plugs
Courtesy of DAIMLERCHRYSLER CORP.

NOTE: When installing spark plug cables, insure a positive connection is made. A snap should be felt when a good connection is made between the spark plug cable and the spark plug.
Insure a firm connection is made from the spark plug cables (2) to the spark plugs.

Fig 4: Identifying Engine Appearance Cover
Courtesy of DAIMLERCHRYSLER CORP.
Install the engine cover (1). Align the engine cover retaining clips to the rubber mounts, and push down firmly to connect engine cover to rubber mounts.
NOTE: To ease the installation of the engine cover, apply a small amount of lubricant to the engine cover rubber mounts.
Connect the negative battery cable.