FixVault
Home › Chrysler › 2006 › Sebring GTC › Repair and Diagnosis › Restraints › Restraints Control Systems › Air Bag Restraint Systems › Satellite Acceleration Sensor › Removal

Satellite Acceleration Sensor: Removal

  1. Disconnect and isolate the battery negative cable remote terminal.
  2. Wait two minutes for the system reserve capacitor to discharge before servicing any airbag components.
  3. Remove the lower B-pillar trim from the appropriate side of the vehicle. Refer to B-PILLAR LOWER TRIM .
  4. Disconnect the satellite acceleration sensor (SAS) electrical connector.
  5. Remove the SAS retaining screws and remove the sensor from the vehicle.
About FixVault