FixVault
Home › Chrysler › 2006 › Sebring GTC › Repair and Diagnosis › Steering › Power Steering › Steering System › Pump › Hose - Supply › Installation

Hose - Supply: Installation

  1. Install supply hose down past engine and onto power steering pump supply fitting. See Figure. See Figure. Install clamp.Be sure hose clamp is installed on hose past upset bead on fitting. 
  2. Install power steering fluid supply hose onto power steering fluid reservoir fitting. See Figure. Install clamp. Be sure hose clamp is installed on hose past upset bead on power steering reservoir fitting. 
  3. Slide reservoir down over guide on engine coolant recovery bottle.
  4. Install power steering fluid reservoir mounting screw and tighten to 6 N.m (53 in. lbs.).
  5. Install remote battery ground cable on ground stud located on left shock tower.
  6. Fill power steering pump fluid reservoir to the proper level.
  7. Start the engine and let run for a few seconds, then turn the engine off.
  8. Fill power steering pump fluid reservoir to the proper level and perform Power Steering Pump Initial Operation standard procedure. (Refer to STEERING/PUMP - STANDARD PROCEDURE) 
  9. Check for leaks.
About FixVault