FixVault
Home › Chrysler › 2006 › Sebring TSi › Repair and Diagnosis › External Pages › Different car › Section 30 (Ignition Control) › Glow Plug › Installation

Glow Plug: Installation

WARNING: This page is about a different car, the 2006 Dodge Sprinter. However, it is still accessible from the selected car via links, so may be relevant.
  1. Screw glow plug(s) into cylinder head and tighten to 12 N.m (115 lbs. in). See Figure.
  2. Connect the glow plug wiring harness connector(s)
  3. Install the engine cover.
  4. Connect negative battery cable.
About FixVault