FixVault
Home › Chrysler › 2007 › 300 Base › Repair and Diagnosis › External Pages › Different car › Section 15 (2.7L Engine (Service Information)) › Arms-Rocker › Installation

Section 15 (2.7L Engine (Service Information)): Arms-Rocker: Installation

WARNING: This page is about a different car, the 2006 Dodge Magnum, 2006 Dodge Charger, and 2006 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Rocker Arm Components
GC0015310Courtesy of DAIMLERCHRYSLER CORP.
  1. Lubricate rocker arms with clean engine oil before installation.
  2. Rotate engine until cam lobe is on its base circle (heel) of rocker arm being installed.
    Fig 2: Rocker Arm - Removal/Installation - 2.7L
    GC0015311Courtesy of DAIMLERCHRYSLER CORP.
  3. Using Special Tools 8215-A (1), 8216-A adaptor (2), and a 3/8" Drive Ratchet (3), depress valve spring only enough to install rocker arm.
  4. Install rocker arm in original position (if reused) over valve and lash adjuster. Release tension on valve spring.
    NOTE: Inspect rocker arm for proper engagement into lash adjuster and valve tip.
  5. Repeat procedure for each rocker arm being installed.
  6. Install cylinder head cover(s). Refer to INSTALLATION .
About FixVault