FixVault
Home › Chrysler › 2007 › 300 Base › Repair and Diagnosis › External Pages › Different car › Section 16 (3.5L Engine (Service Information)) › Cover-Rear Timing Belt › Removal

Cover-Rear Timing Belt: Removal

WARNING: This page is about a different car, the 2006 Dodge Magnum, 2006 Dodge Charger, and 2006 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Timing Belt Rear Cover
GC0015459Courtesy of DAIMLERCHRYSLER CORP.
1 - M8 FASTENERS (APPLY THREAD SEALANT)
2 - M10 FASTENERS
3 - M6 FASTENERS
4 - M10 FASTENERS (STUD/NUT)
NOTE: The rear timing belt cover has O-rings to seal the water pump passages to cylinder block. Do not reuse the O-rings.
  1. Perform fuel pressure release procedure. Refer to STANDARD PROCEDURE - FUEL SYSTEM PRESSURE RELEASE PROCEDURE .
  2. Disconnect the negative battery cable.
  3. Remove timing belt. (Refer to ENGINE/VALVE TIMING/TIMING BELT/CHAIN AND SPROCKETS - REMOVAL) .
  4. Remove camshaft sprockets. (Refer to ENGINE/VALVE TIMING/TIMING BELT/CHAIN AND SPROCKETS - REMOVAL) .
  5. Remove rear timing belt cover bolts (1, 2, 3). See Fig 1.
  6. Remove the rear cover.
About FixVault