FixVault
Home › Chrysler › 2007 › 300 Base › Repair and Diagnosis › External Pages › Different car › Section 165 (Electronic Control Modules (Service Information)) › Electronic Control Modules - Service Information › Module-Heated Seat › Removal › Heated Seat Module

Heated Seat Module

WARNING: This page is about a different car, the 2007 Chrysler PT Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Locating Heated Seat Module
GC0043475Courtesy of CHRYSLER LLC
CAUTION: The Heated Seat Module mounting tab can be damaged during module removal and installation. Use care to properly align tab to prevent binding that could result in tab breakage.
  1. Position the right front seat to the full rearward position.
  2. Disconnect and isolate the battery negative cable.
  3. Disconnect the wire harness connector (4) from the heated seat module (3).
  4. Unsnap the heated seat module retaining tab (2) from the seat pan (1).
  5. Remove the heated seat module (3) from the vehicle.
About FixVault