FixVault
Home › Chrysler › 2007 › 300 Base › Repair and Diagnosis › External Pages › Different car › Section 32 (Anti-Lock Brake System (Service Information)) › Sensor-Front Wheel Speed › Installation › AWD

Sensor-Front Wheel Speed: Installation: AWD

WARNING: This page is about a different car, the 2006 Dodge Magnum, 2006 Dodge Charger, and 2006 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Wheel Speed Sensor At Front Knuckle - AWD
GC0014045Courtesy of DAIMLERCHRYSLER CORP.
  1. Install wheel speed sensor (2) head into knuckle (4) and install mounting screw (1). Tighten screw to 11 N.m (95 in. lbs.) torque.
  2. Attach wheel speed sensor cable and routing clip (3) to knuckle (4).
    Fig 2: Wheel Speed Sensor at Body - AWD
    GC0014652Courtesy of DAIMLERCHRYSLER CORP.
  3. Attach sensor cable routing clip (2) to brake hose bracket (3).
  4. Connect sensor connector (1) to body wiring harness connector (4). When installing connector, make sure retaining clip on body connector is properly in place and sensor connect cannot be pulled out.
  5. Lower vehicle.
  6. Perform Verification Test and clear any faults. (Refer to BRAKES - DIAGNOSIS AND TESTING)
About FixVault