FixVault
Home › Chrysler › 2007 › 300 Base › Repair and Diagnosis › External Pages › Different car › Section 33 (Restraints System (Service Information)) › Seat Track Position Sensor › Installation

Seat Track Position Sensor: Installation

WARNING: This page is about a different car, the 2006 Dodge Magnum, 2006 Dodge Charger, and 2006 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Removing/Installing Seat Track Position Sensor
GC0016671Courtesy of DAIMLERCHRYSLER CORP.
  1. Position the seat track position sensor (3) on the end of the bracket (1) located on the lower outboard seat track (5).
  2. Push the sensor firmly into the bracket until the snap feature (2) locks into place.
  3. Connect the electrical connector (4) to the sensor.
WARNING: Do not connect the battery negative cable (Refer to AIRBAG SYSTEM ). Personal injury or death may result if the system test is not performed first.
WARNING: Following successful completion of the Airbag System test procedure, the Occupant Classification System Verification Test must be done using a scan tool and the appropriate diagnostic information.
About FixVault