Intrusion Sensor - Export: Removal: Transmitter
WARNING: This page is about a different car, the 2006 Dodge Magnum, 2006 Dodge Charger, and 2006 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect and isolate the battery negative cable.
- If replacing the bezel, pull the bezel (1) inboard from the C-pillar (3), or use a trim stick or equivalent to unsnap it from the transducer housing (2) of the intrusion sensor transmitter.
- Remove the C-pillar trim panel (Refer to BODY/INTERIOR/C-PILLAR TRIM - REMOVAL) .
- Remove the two retaining screws from the C-pillar and remove the sensor.