FixVault
Home › Chrysler › 2007 › Crossfire Base, 2D Convertible › Repair and Diagnosis › Suspension › Front Suspension › Suspension System › Wheel Alignment › Standard Procedure › Inspecting And Adjusting Using Electronic Inclinometer

Inspecting And Adjusting Using Electronic Inclinometer

  1. Observe the general information on chassis alignment inspection. See STANDARD PROCEDURE .
    CAUTION: The measuring plate is magnetic. Information on data media, e.g. floppy disks, credit cards, etc, could be rendered unusable.
    NOTE: Be sure to clean measurement points on the lower wishbone.
    NOTE: Remove any metal shavings on the measuring plate.
  2. Install the measuring plate in the recessed area in the lower control arm. The groove in the measuring plate should be at an angle of 90° towards the direction of travel.
  3. Inspect the vehicle level at the front axle via control arm inclination. See STANDARD PROCEDURE .
  4. Inspect the vehicle level at the rear axle via the rear axle shaft inclination. See STANDARD PROCEDURE .
  5. Adjust the vehicle level at the front and rear axles. If the vehicle level is outside the allowed tolerance at the front or rear axle, perform the following:
    1. Adjust the vehicle level by changing the springs or the spring rubber mounts. See STANDARD PROCEDURE .
About FixVault