FixVault
Home › Chrysler › 2007 › Sebring Base, 2.4 K › Repair and Diagnosis › Engine Mechanical › Fuel System › Fuel Injection › Fuel Injector › Installation › Injector-Fuel - 3.5L

Injector-Fuel - 3.5L

Fig 1: Fuel Injector O-Ring
GC0000403Courtesy of CHRYSLER LLC
  1. Lightly lubricate the fuel injector O-rings with a couple drops of clean engine oil.
  2. Install retaining clips on fuel injectors.
    Fig 2: Installing Fuel Injector
    GC0000405Courtesy of CHRYSLER LLC
  3. Push injectors into fuel injector rail until clips are in the correct position.
    Fig 3: Identifying Fuel Rail
    GC0049839Courtesy of CHRYSLER LLC
  4. Lightly lubricate the fuel injector O-rings with a couple drops of clean engine oil.
    Fig 4: Identifying Fuel Rail Bolts
    GC0049840Courtesy of CHRYSLER LLC
  5. Position fuel rail over cylinder heads, and push rail into place. Tighten fuel rail mounting bolts to 28 N.m (250 in. lbs.) torque.
  6. Connect the fuel supply tube quick connect fitting to the fuel rail. Refer to QUICK CONNECT FITTING .
  7. Connect and lock the electrical connectors to the fuel injectors.
  8. Install intake manifold plenum. Refer to appropriate Engine SERVICE INFORMATION article.
  9. Connect negative cable to battery.
About FixVault