Engine & Automatic Transmission Cooling System: Engine: Pump-Water: Installation: Installation-3.5L

Fig 1: Identifying Water Pump - 3.5L Engine

Courtesy of CHRYSLER LLC

1 - O-RING

2 - IMPELLER

3 - WATER PUMP BODY

1. Clean all O-ring surfaces on pump and cover.
2. Apply Mopar® Dielectric Grease or the equivalent silicone grease to the O-ring to facilitate assembly. Install new O-ring on water pump.
3. Position water pump to engine.
4. Install mounting bolts and tighten to 12 N.m (105 in. lbs.).
5. Install timing belt. Refer to appropriate Engine SERVICE INFORMATION article.
6. Fill cooling system. See STANDARD PROCEDURE .