Bushing-Rear CROSSMEMBER Spring Link

Fig 1: Installing Spring Link Bushing

Courtesy of CHRYSLER LLC

1 - BUSHING

2 - REMOVER/INSTALLER 9032-2

3 - PRESS C-4212F

4 - RECEIVER 9032-3

1. Position bushing (1) over rear of crossmember bushing bore.
2. Assemble tools over bushing and crossmember as shown (See list). Ensure Receiver, Special Tool 9032-3, is positioned to avoid welds on rear of crossmember bushing bore.
   1. (2) Remover/Installer 9032-2
   2. (3) Press C-4212F
   3. (4) Receiver 9032-3
3. Tighten Press screw-drive, pressing bushing into crossmember. Install bushing until screw-drive stops, when bushing contacts Receiver on opposite side of crossmember.
4. Remove tools.
   Fig 2: Spring Link Mounting

   Courtesy of CHRYSLER LLC
5. Swing spring link up to bushing in crossmember and install bolt and nut (1) fastening spring link (4) to crossmember. Do not tighten bolt at this time. 
   Fig 3: Headlamp Leveling Sensor

   Courtesy of CHRYSLER LLC
6. Export Only - If servicing right side bushing, connect headlamp leveling sensor (1) link at spring link (3).
7. Install rear spring as well as all components necessary to access it. Refer to INSTALLATION .
8. Lower vehicle.
9. Position vehicle on alignment rack/drive-on lift. Raise vehicle as necessary to access mounting bolt.
   Fig 4: Spring Link Mounting

   Courtesy of CHRYSLER LLC
10. Tighten spring link bolt (1) at crossmember to 108 N.m (80 ft. lbs.).
11. Perform wheel alignment. Refer to STANDARD PROCEDURE .