Module-Sentry Key Remote Entry

Fig 1: Removing/Installing Sentry Key Remote Entry Module (SKREEM) Or Wireless Control Module (WCM)

Courtesy of CHRYSLER LLC

NOTE: The steering wheel does not have to be removed to service the SKREEM/WCM.

NOTE: The Steering Column Control Module (SCCM) assembly, which consists of the left/right multi-function switches and the clockspring, does not have to be removed to service the SKREEM/WCM. After removing the right multi-function switch (refer to REMOVAL ), there is an access hole to access the SKREEM mounting screw (2).

Disconnect and isolate the battery negative cable.
WARNING: Wait two minutes for the airbag system reserve capacitor to discharge before beginning any airbag system or component service. Failure to do so may result in accidental airbag deployment, personal injury or death.
Remove the upper and lower steering column shrouds. Refer to REMOVAL - UPPER SHROUD, and REMOVAL - LOWER SHROUD.
Remove the right multi-function switch. Refer to REMOVAL .
Remove the SKREEM/WCM mounting screw (2) on the ignition lock assembly and separate the SKREEM/WCM (3) from the ignition lock assembly.

Fig 2: Locating Sentry Key Remote Entry Module (SKREEM) Or Wireless Control Module (WCM) Housing
Courtesy of CHRYSLER LLC
Disconnect the SKREEM/WCM electrical connector (4).
Remove SKREEM/WCM (1 and 3) from column (2).

When a PCM and the SKREEM/WCM are replaced at the same time, perform the following steps in order. Refer to STANDARD PROCEDURE - ELECTRICAL DIAGNOSTICS article. Refer to STANDARD PROCEDURE - SERVICE INFORMATION article.

Program the new PCM.
Program the new SKREEM/WCM.
Replace all ignition keys and program them to the new SKREEM/WCM.