Battery Reconnection: Notes

WARNING: This page is about a different car, the 2010 Dodge Charger and 2010 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: This reconnection procedure is to be performed anytime the battery has been disconnected.

Fig 1: Disconnecting/Connecting Battery Cables

Courtesy of CHRYSLER LLC

Connect the battery negative cable (2) to the battery post and tighten the clamp nut.
Install the rear compartment floor trim panel.
CAUTION: Once the battery has been connected, review and perform the following information as applicable.

NOTE: Make sure battery is fully charged before proceeding.

NOTE: This needs to be completed every time the window glass is adjusted/removed, motor replaced, and or regulator replaced.