2.4L Turbo

Fig 1: GENERATOR LOCATION - 2.4L TURBO

Courtesy of CHRYSLER LLC

The generator is located above the oil filter and axle shaft.

1. Disconnect the negative battery cable.
   Fig 2: GENERATOR HEAT SHIELD

   Courtesy of CHRYSLER LLC
2. Remove the 2 bolts from the top of the heat shield on the generator.
   Fig 3: Generator T-Bolt Locknut And Adjustment Bolt

   Courtesy of CHRYSLER LLC
3. Remove nut from the upper T-bolt adjustment bracket.
   Fig 4: Accessory Drive Splash Shield

   Courtesy of CHRYSLER LLC

   1 - ACCESSORY DRIVE BELT SPLASH SHIELD

4. Raise vehicle and support.
5. Remove the right front wheel.
6. Remove the accessory drive splash shield.
7. Remove the lower heat shield bolt.
8. Remove the generator heat shield.
   Fig 5: Battery Connection

   Courtesy of CHRYSLER LLC

   1 - FIELD CONNECTOR

   2 - BATTERY CONNECTION

9. Unplug field circuit connector (1) from generator.
10. Remove the B+ terminal nut (2) and B+ terminal.
    Fig 6: Strut Mounting

    Courtesy of CHRYSLER LLC

    1 - NUT

    2 - PENCIL STRUT

    3 - NUT

    4 - FLAT WASHER

    5 - LOWER TORQUE STRUT

11. Remove the pencil strut (2).
    Fig 7: Lower Pivot Bolt

    Courtesy of CHRYSLER LLC

    1 - LOWER PIVOT BOLT

12. Loosen the lower generator pivot bolt (1).
13. Loosen the accessory drive belt T-bolt.
    Fig 8: AXLE SHAFT

    Courtesy of CHRYSLER LLC

    1 - Axle Shaft

    2 - Lower Control Arm

    3 - Steering Knuckle

14. Remove the generator belt. Refer to Cooling/Accessory Drive/BELT, Serpentine - Removal .
15. Remove the axle shaft assembly. Refer to Differential and Driveline/Half Shaft - Removal .
    Fig 9: LOWER MOUNTING BRACKET

    Courtesy of CHRYSLER LLC
16. Remove the generator from the lower mounting bracket and set generator to the side.
17. Remove the lower mounting bracket for the generator.
    Fig 10: GENERATOR REMOVAL/INSTALLATION

    Courtesy of CHRYSLER LLC
18. Remove generator through the axle shaft hole.