FixVault
Home › Chrysler › 2011 › 300 Base, Gas › Repair and Diagnosis › External Pages › Different car › Section 453 (Engine Cooling System) › Engine › Radiator, Engine Cooling › Installation › Installation

Radiator, Engine Cooling: Installation: Installation

WARNING: This page is about a different car, the 2013 Dodge Avenger and 2013 Chrysler 200. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying A/C Line
GC0120904Courtesy of CHRYSLER GROUP, LLC
1 - A/C LINE
2 - SUPPORT BRACKET
  1. Position the A/C condenser onto the radiator.
  2. Slide the radiator/condensor assembly into position and seat the radiator assembly lower rubber isolators in the mount holes.
  3. Install the mounting brackets to the upper core support using two torx screws.
  4. Install A/C lines to condenser/cooler.
  5. Install transmission oil cooler tubes support bracket to radiator (2). Tighten mounting screws to 5 N.m (45 in. lbs.).
  6. Position radiator cooling fan assembly on radiator. Refer to FAN, COOLING, INSTALLATION .
    Fig 2: Identifying Upper Radiator Hose
    GC0120903Courtesy of CHRYSLER GROUP, LLC
    1 - ELECTRICAL CONNECTOR
    2 - UPPER RADIATOR HOSE
  7. Install upper and lower radiator hoses at radiator.
  8. Install the front bumper facia. Refer to FASCIA, FRONT, INSTALLATION .
  9. Install front bottom splash shield (if equipped).
  10. Install under belly pan (if equipped).
  11. Fill cooling system. Refer to STANDARD PROCEDURE .
  12. Charge A/C system. Refer to PLUMBING, STANDARD PROCEDURE .
  13. Install air box assembly. Refer to BODY, AIR CLEANER, INSTALLATION for 2.4L or BODY, AIR CLEANER, INSTALLATION for 3.6L.
  14. Connect negative battery cable.
  15. Install engine cover.
About FixVault