FixVault
Home › Chrysler › 2013 › 300 SRT-8 Core › Repair and Diagnosis › External Pages › Different variant/trim › Section 3 (Front Axle) › Installation › Installation

Section 3 (Front Axle): Installation: Installation

WARNING: This page is about a different variant/trim than selected.
Fig 1: Removing/Installing Front Axle
GC0081412Courtesy of CHRYSLER GROUP, LLC
  1. Install front axle assembly (1) into position. Install and tighten axle housing-to-engine bolts to 65 N.m (48 ft. lbs.).
    Fig 2: Return Hose Routing Clips
    GC0080564Courtesy of CHRYSLER GROUP, LLC
  2. Install power steering return line to cradle by fastening clips (1).
    Fig 3: Front Drive Axle Housing
    GC0081411Courtesy of CHRYSLER GROUP, LLC
  3. Install axle assembly support bracket (1) and torque bolts to 28 N.m (21 ft. lbs.).
  4. Install RH catalytic converter/exhaust pipe assembly. Refer to CONVERTER, CATALYTIC, INSTALLATION .
  5. Install front propeller shaft. Refer to INSTALLATION .
  6. Install intermediate shaft. Refer to REMOVAL .
  7. Install both front halfshafts. Refer to INSTALLATION .
    Fig 4: Fluid Fill Plug Location
    GC0081451Courtesy of CHRYSLER GROUP, LLC
  8. Fill axle with 600ml (0.64 qts.) of Mopar® 75W-90 Synthetic Gear Lubricant. Fluid level should be at or near bottom of fill hole. Torque fill plug (1) to 30 N.m (22 ft. lbs.).
  9. Lower vehicle.
About FixVault