Update Pressure Thresholds

WARNING: This page is about a different car, the 2013 Dodge Avenger and 2013 Chrysler 200. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

The wiTECH software level must be at the latest release to perform this procedure.

NOTE:

The vehicle must be driven before the TPMS light will turn off.

CAUTION:

Read all notes and cautions for programming procedures.

NOTE:

Have the vehicle PIN readily available before running the routine

Connect a battery charger to the vehicle.
With the wiTECH diagnostic application, perform the following steps:

Select "WIRELESS CONTROL MODULE (WCM)"
Select the "MISCELLANEOUS FUNCTIONS" tab
Highlight and select "UPDATE PRESSURE THRESHOLDS"
Note On-Screen instructions and select the "NEXT" button
Verify current settings, select the "NEXT" button to change settings
Select "NEXT"
Enter the PIN when prompted.
Select "NEXT"
Verify that the PIN number is correct
Once verified, select "NEXT"
Select "NEXT"
Wait for the WCM to update it's configuration
Once the WCM configuration is complete, select "NEXT"
Note On-Screen instructions and select the "FINISH" button