Section 14 (Engine Cooling System): Specifications: Torque
WARNING: This page is about a different car, the 2013 Dodge Avenger and 2013 Chrysler 200. However, it is still accessible from the selected car via links, so may be relevant.
| DESCRIPTION | N.m | Ft. Lbs. | In. Lbs. |
|---|---|---|---|
| Fastener-Accessory Drive Belt Tensioner Assembly(2.4L) | 54 | 40 | - |
| Fastener-Accessory Drive Belt Tensioner (2.4L) | 24 | 18 | - |
| Fastener-Accessory Drive Belt Tensioner (3.6L) | 55 | 41 | - |
| Fastener-Idler Pulley (2.4L) | 50 | 37 | - |
| Fastener-Idler Pulley (3.6L) | 25 | 18 | - |
| Fasteners-A/C Condenser to Radiator | 5 | - | 44 |
| Fastener-Block Heater (3.6L) | 12 | 9 | 106 |
| Bolts-Coolant Outlet Connector (3.6L) | 12 | 9 | 106 |
| Cooling System Bleed Valve | 2 | - | - |
| ETC Sensor (2.4L) | 17 | 13 | - |
| ETC Sensor (3.6L) | 22 | 16 | - |
| Fasteners-Fan Module to Radiator | 5 | - | 44 |
| Fasteners-Fan Motor to Shroud | 5 | - | 44 |
| Bolts-Thermostat Housing (3.6L) | 12 | 9 | 106 |
| Bolts-Thermostat Housing to cylinder head (2.4L) | 18 | 13 | - |
| Fastener-Transmission Cooler Tube Bracket | 5 | - | 44 |
| Fastener-Transmission Cooler Tube | 9 | - | 80 |
| Fitting - Transmission oil cooler quick connect fitting | 15 | 11 | - |
| Bolts-Water Pump (3.6L) | |||
| M6 | 12 | 9 | 106 |
| M8 | 25 | 18 | - |
| M10 | 55 | 41 | - |
| Hose Clamps-Transmission Cooler | 3 | - | 27 |
| Bolts-Water Pump Mounting (2.4L) | 24 | 18 | - |
| Bolts-Water Pump Inlet Tube to Block (2.4L) | 12 | 9 | 106 |
| Bolts-EGR Bypass assembly-to EGR Cooler body | 10 | 7 | 89 |
| Bolts-EGR Tube -to-Exhaust manifold | 20 | 15 | - |
| Bolts, Water Pump Inlet Tube to water pump housing (2.4L) | 24 | 18 | - |
| Bolts, Water Pump to Water Pump Adapter (2.4L) | 22 | 16 | - |
| Bolts, Water Pump Pulley to Water Pump (2.4L) | 9 | - | 80 |