FixVault
Home › Chrysler › 2014 › 300 Base, 4WD, Gas › Repair and Diagnosis › External Pages › Different car › Section 128 (Electronic Control Modules (Service Information)) › Module, Telematics Gateway › Installation › Installation

Module, Telematics Gateway: Installation: Installation

WARNING: This page is about a different car, the 2013 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the Telematics Gateway Module (TGM) close to the instrument panel to connect the electrical connectors.
    Fig 1: Antenna(s), Video Cable, RF HUB, Wiring Connectors And UCI Cables
    GC0144027Courtesy of CHRYSLER GROUP, LLC
    NOTE:

    Mid level shown in the illustration, base similar.

  2. If equipped, connect the antenna(s) (1), RF Hub and UCI cables (4), video cable (3) and wiring connectors (2) to the TGM.
    Fig 2: Telematics Gateway Assembly
    GC0144554Courtesy of CHRYSLER GROUP, LLC
  3. Position the telematics gateway module into the instrument panel cavity and install the TGM (1) retainers. Tighten the fasteners securely.
    Fig 3: Switch Bank
    GC0144517Courtesy of CHRYSLER GROUP, LLC
  4. Install the switch bank (2). Refer to POD, SWITCH BANK, INSTALLATION .
  5. Connect the negative battery cable.
  6. Restore user data from backup. Refer to STANDARD PROCEDURE .
About FixVault