FixVault
Home › Chrysler › 2014 › 300 SRT-8 › Repair and Diagnosis › External Pages › Different car › Section 128 (Electronic Control Modules (Service Information)) › Module, Telematics Gateway › Removal › Removal

Module, Telematics Gateway: Removal: Removal

WARNING: This page is about a different car, the 2013 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
  1. Perform a complete backup of user data. Refer to STANDARD PROCEDURE .
  2. Disconnect the negative battery cable.
  3. Before proceeding with the following repair procedure, review all warnings and cautions.
    Fig 1: Switch Bank
    GC0144517Courtesy of CHRYSLER GROUP, LLC
  4. Remove the switch bank. Refer to POD, SWITCH BANK, REMOVAL .
    Fig 2: Telematics Gateway Assembly
    GC0144554Courtesy of CHRYSLER GROUP, LLC
  5. Remove the Telematics Gateway Module (TGM) (1) retainers.
  6. Pull the TGM out far enough to access the harness connectors.
    Fig 3: Antenna(s), Video Cable, RF HUB, Wiring Connectors And UCI Cables
    GC0144027Courtesy of CHRYSLER GROUP, LLC
    CAUTION:

    Pulling the antenna cable straight out of the radio without pulling on the locking antenna connector could damage the cable or radio.

  7. If equipped, disconnect the antenna(s) (1), RF Hub and UCI cables (4), video cable (3) and wiring connectors (2) from the TGM.
  8. Remove the TGM from the vehicle.
About FixVault