FixVault
Home › Chrysler › 2015 › 200 LX, Eng CD ED8 › Repair and Diagnosis › External Pages › Different variant/trim › Section 2 (Rear Driveline Module) › Sensor, Pressure › Removal › Pressure Sensor Removal

Pressure Sensor Removal

WARNING: This page is about a different variant/trim than selected.
Fig 1: Identifying Pressure Sensor And Pump Motor Electrical Connectors
GC0159204Courtesy of CHRYSLER GROUP, LLC
  1. Disconnect the wire harness connector from the pressure sensor (1).
  2. Position a drain pan under the differential and remove the pressure sensor (1) from the RDU housing.
About FixVault