FixVault
Home › Chrysler › 2016 › 200 LX, Eng CD ED8 › Repair and Diagnosis (Single Page) › Accessories & Equipment › Communication Devices › Electronic Control Modules (Service Information) › Module, Powertrain Control › Installation › 3.6L

Module, Powertrain Control: Installation: 3.6L

Fig 1: Battery Tray, PCM Mount & Bolts
GC0159726Courtesy of CHRYSLER GROUP, LLC
CAUTION:

If a new powertrain control module is being installed, use a scan tool to reprogram the new module with the original vehicle identification number (VIN) and original mileage. If this step is not performed, a Diagnostic Trouble Code (DTC) will set.

  1. If removed, install the PCM mount (3). Tighten the bolts (2) to the proper specification. Refer to SPECIFICATIONS .
    Fig 2: Powertrain Control Module Electrical Connectors & Nuts
    GC0159669Courtesy of CHRYSLER GROUP, LLC
  2. Position the PCM onto the mount.
  3. Install the ground wire. Tighten the nut (2) to the proper specification. Refer to SPECIFICATIONS .
  4. Install the nuts (3) and tighten to the proper specification. Refer to SPECIFICATIONS .
  5. Install the PCM electrical connectors.
  6. Connect the battery negative cable.
  7. Perform PCM programming. Refer to MODULE, POWERTRAIN CONTROL, MODULE PROGRAMMING .
About FixVault