Charging System (Service Information): Generator: Installation: 2.4L

Fig 1: Generator Stud, Bolts & Connector

Courtesy of CHRYSLER GROUP, LLC

1. Install the generator to the engine block. Tighten the bolts to the proper SPECIFICATIONS .
2. Install the positive cable to the rear of the generator stud. Tighten the nutto the proper SPECIFICATIONS .
3. Connect the field generator harness connector.
   Fig 2: Accessory Drive Belt

   Courtesy of CHRYSLER GROUP, LLC
4. Install the accessory drive belt. Refer to BELT, SERPENTINE, INSTALLATION .
5. Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector to the negative battery cable.
6. Install the engine cover.