FixVault
Home › Chrysler › 2017 › 200 LX, Eng CD ED8 › Repair and Diagnosis › Accessories & Equipment › Communication Devices › Electronic Control Modules (Service Information) › Module, Body Control › Removal

Module, Body Control: Removal

WARNING:

To avoid serious or fatal injury on vehicles equipped with airbags, disable the Supplemental Restraint System (SRS) before attempting any steering wheel, steering column, airbag, Occupant Classification System (OCS), seat belt tensioner, impact sensor or instrument panel component diagnosis or service. Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the SRS. Failure to follow these instructions may result in accidental airbag deployment.

GC0159260Courtesy of CHRYSLER GROUP, LLC
  1. Disconnect and isolate the battery negative cable.
  2. Remove the knee blocker cover from the instrument panel. Refer to KNEEBLOCKER, REMOVAL .
  3. Remove the lower left side A-Pillar extension trim.
  4. Disconnect up to eight wire harness connectors from the connector receptacles of the Body Control Module (BCM).
  5. Remove the four screws (1) that secure the yoke-like BCM mounting brackets to the instrument panel support structure outboard of the steering column.
  6. Remove the BCM and mounting brackets from the instrument panel as a unit.
  7. Remove the four screws that secure the BCM to the mounting brackets (2).
  8. Unsnap and remove the BCM from the mounting brackets.
About FixVault