Removal And Installation: Rear: Installation

WARNING: This page is about a different variant/trim than selected.

NOTE:

Illustration shown with instrument panel removed from view for clarity.

Courtesy of CHRYSLER GROUP, LLC

Position the HVACR module (2) to the housing.
Install and tighten the two HVACR module to the housing screws (1).
Connect the HVACR module electrical connector (3).
Install the right rear quarter trim panel. Refer to PANEL, QUARTER TRIM, REMOVAL AND INSTALLATION .
Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector to the negative battery cable.
Initiate the Actuator Calibration function using a scan tool. Refer to STANDARD PROCEDURE .