FixVault
Home › Chrysler › 2018 › 300 C › Repair and Diagnosis › Accessories & Equipment › Drivers Assistance Systems - ADAS › Electronic Control Modules (Service Information) › Module, HVAC › Installation

Module, HVAC: Installation

NOTE:

Illustration shown with instrument panel removed from view for clarity.

GC0144553Courtesy of CHRYSLER GROUP, LLC
  1. Position the HVAC module (1) to the air inlet housing (4) and engage the module to the two front retaining screws (2).
  2. Loosely install the screw (5) that secures the rear of the HVAC module to the air inlet housing.
  3. Tighten all the screws that secure the HVAC module to the air inlet housing to 2 N.m (17 in. lbs.).
  4. Connect the wire harness connector (3) to the HVAC module.
  5. Install the glove box trim panel and glove box. Refer to GLOVE BOX, INSTRUMENT PANEL, INSTALLATION .
  6. Install the right side instrument panel silencer. Refer to PANEL, SILENCER, INSTALLATION .
  7. Reconnect the negative battery cable.
  8. Initiate the Actuator Calibration function using a scan tool. Refer to STANDARD PROCEDURE .
About FixVault