Sensor, Crankshaft Position: Installation: 3.6L

Courtesy of CHRYSLER GROUP, LLC

The Crankshaft Position (CKP) sensor O-ring (1) can be reused if not damaged.
Apply a small amount of engine oil to the CKP sensor O-ring (1).

Courtesy of CHRYSLER GROUP, LLC
Clean out the CKP sensor mounting bolt hole in the engine block.
CAUTION:
Before tightening the CKP sensor mounting bolt, be sure the sensor is completely flush to the cylinder block. If the CKP sensor is not flush, damage to the sensor mounting tang may result.
Install the CKP sensor (1) into the engine block. Tighten bolt (2) to the proper torque specifications. Refer to TORQUE SPECIFICATIONS .

Courtesy of CHRYSLER GROUP, LLC
Connect the CKP sensor wire harness connector (1).

Courtesy of CHRYSLER GROUP, LLC
Install the heat shield (1) over the CKP sensor.
If equipped with All Wheel Drive (AWD), You must install the front propeller shaft. Refer to INSTALLATION .

Courtesy of CHRYSLER GROUP, LLC
Install the belly pan and securely tighten bolts (1).
Remove support and lower the vehicle.
Connect the negative battery cable.

NOTE:

The Cam/Crank Variation Relearn procedure must be performed using the scan tool anytime there has been a repair/replacement made to a powertrain system, for example: flywheel, valvetrain, camshaft and/or crankshaft sensors or components.