FixVault
Home › Chrysler › 2018 › 300 C › Repair and Diagnosis › External Pages › Different car › Section 2 (Electronic Control Modules (Service Information)) › Module, Radio Frequency (RF Hub) › Removal

Module, Radio Frequency (RF Hub): Removal

WARNING: This page is about a different car, the 2018 Dodge Challenger. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
  2. Remove the rear shelf cover. Refer to PANEL, REAR SHELF, REMOVAL .
    GC0170521Courtesy of CHRYSLER GROUP, LLC
  3. Remove the Remote Frequency Hub (RFH) retainers (1).
  4. If equipped, disconnect the remote start antenna (3).
  5. Remove the RFH from the vehicle.
About FixVault