Motor, Window Regulator: Removal
- Partially raise or lower the door glass to relieve tension on motor and cables where possible. Secure the glass as necessary.
- Disconnect and isolate the negative battery cable.
- Remove the door interior trim panel. Refer to PANEL, DOOR TRIM, REMOVAL
for the appropriate procedure. Refer to PANEL, REAR DOOR TRIM, INSTALLATION
.
- Disconnect the power window motor wire harness connector (3).
- Remove the fasteners (2) that secure the power window motor and gear assembly (1) to the carrier plate.
- Using a suitable flat bladed tool, lightly pry the cable drive (1) away from the motor (2) and remove the motor and gear assembly.