Pump, Water: Installation: 3.6L

Courtesy of CHRYSLER GROUP, LLC

Clean the gasket mating surfaces.
NOTE:
Note the lengths of the mounting bolts. Some M6 bolts (2) mount directly to the timing cover.
Using a NEW gasket, install the water pump (1) and tighten the bolts finger tight, including the idler pulley (4) and mounting bolt.

Fig 1: Water Pump Bolts Tightening Sequence
Courtesy of CHRYSLER GROUP, LLC
Using the sequence shown in illustration, tighten the bolts 1-12 to their proper torque:
- Tighten the M6 bolts to the proper torque specification. Refer to TECHNICAL SPECIFICATIONS .
- Tighten the M8 bolts (10, 11) to the proper torque specification. Refer to TECHNICAL SPECIFICATIONS .
- Tighten the M10 bolt (12) to the proper torque specification. Refer to TECHNICAL SPECIFICATIONS .
Courtesy of CHRYSLER GROUP, LLC
Install the lower radiator hose (2).
Install the lower return heater hose (1).
CAUTION:
When installing the serpentine accessory drive belt, belt must be routed correctly. If not, engine may overheat due to water pump rotating in wrong direction.
Install the accessory drive belt. Refer to BELT, SERPENTINE, INSTALLATION .
Evacuate air and refill the cooling system. Refer to STANDARD PROCEDURE .
Connect the negative battery cable.
Check the cooling system for leaks. Refer to DIAGNOSIS AND TESTING .