FixVault
Home › Chrysler › 2023 › Pacifica Hybrid Limited › Repair and Diagnosis › External Pages › Different variant/trim › Section 19 (Electronic Control Modules (Service Information)) › Module, Keyless Ignition Node (Kin) › Removal And Installation › Keyless Ignition Node (Kin) Module › Removal

Keyless Ignition Node (Kin) Module: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
  2. Remove the steering column opening cover. Refer to COVER, STEERING COLUMN OPENING, REMOVAL AND INSTALLATION .
    GC0177301Courtesy of CHRYSLER GROUP, LLC
    1 - KIN Module
    2 - Wire Harness Connector
  3. Disconnect the wire harness connector from the back of the Keyless Ignition Node (KIN) module.
  4. Remove the center instrument trim panel. Refer to PANEL, INSTRUMENT PANEL TRIM, CENTER, REMOVAL AND INSTALLATION .
    GC0177552Courtesy of CHRYSLER GROUP, LLC
    1 - Release Tabs
  5. To remove the KIN from the trim panel, depress the release tabs and push the KIN outward from the inside of the panel until free.
About FixVault