FixVault
Home › Chrysler › 2023 › Pacifica Hybrid Limited › Repair and Diagnosis › External Pages › Different variant/trim › Section 19 (Electronic Control Modules (Service Information)) › Module, Power Liftgate (PLGM) › Removal And Installation › Power Liftgate Module (PLGM) › Removal

Power Liftgate Module (PLGM): Removal

WARNING: This page is about a different variant/trim than selected.

HORIZONTAL POSITION 

  1. Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
  2. Position the right rear quarter trim panel aside in the rear enough to gain access to the module. Refer to PANEL, QUARTER TRIM, REMOVAL AND INSTALLATION .
    GC0178017Courtesy of CHRYSLER GROUP, LLC
    1 - PLGM
    2 - Wire Harness Connectors
  3. Disconnect the wire harness connectors from the Power LiftGate Module (PLGM).
    GC0177899Courtesy of CHRYSLER GROUP, LLC
    1 - Mounting Tab
    2 - Alignment Mounting Tabs
  4. Depress the alignment mounting tab and lift up on the that section of the module and pull slightly aft to disengage the rear alignment mounting tabs.
  5. Remove the PLGM from the vehicle.

VERTICAL POSITION 

  1. Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
  2. Position the right rear quarter trim panel aside in the rear enough to gain access to the module. Refer to PANEL, QUARTER TRIM, REMOVAL AND INSTALLATION .
  3. Remove the right rear wheelhouse splash shield. Refer to SHIELD, SPLASH, REAR WHEELHOUSE, REMOVAL AND INSTALLATION .
    GC0178152Courtesy of CHRYSLER GROUP, LLC
    1 - Body Nut
    2 - Nut
  4. Remove the A/C line to body nut.
    NOTE:

    This step is necessary to prevent damage to the A/C lines in Step 7.

  5. Remove the rear floor distribution duct. Refer to DUCT, FLOOR DISTRIBUTION, REAR, REMOVAL AND INSTALLATION .
  6. Remove the rear ceiling distribution duct. Refer to DUCT, CEILING DISTRIBUTION, REMOVAL AND INSTALLATION .
    GC0178220Courtesy of CHRYSLER GROUP, LLC
    1 - Inner Quarter Fastener
    2 - Inner Quarter Panel Bolts
    3 - HVAC Housing
  7. Remove the two HVAC housing to inner quarter panel bolts.
  8. Carefully pull the top of rear HVAC housing three inches away from the rear inner quarter panel to gain access to the blower motor fasteners and electrical connector.
    NOTE:

    Extending the HVAC housing greater than three inches from the rear inner quarter panel could result in damage to the A/C lines.

    GC0200267Courtesy of CHRYSLER GROUP, LLC
    1 - Wire Harness Connectors
    2 - PLGM
    3 - Alignment Mounting Tab
  9. Disconnect the wire harness connectors from the Power LiftGate Module (PLGM).
  10. Depress the alignment mounting tab and lift up on the that section of the module and pull slightly aft to disengage the upper alignment mounting tabs.
About FixVault