Remote Start System

Before attempting to diagnose a problem with the remote starting system, first be sure the starter motor and starter solenoid are working properly. The starter should operate with the use of the keyless go switch. Any starter or solenoid problems must be repaired first.

Also be sure the engine will easily start and run with the use of the keyless go switch. Any engine running, idling or performance concerns must be addressed first.

All of the following conditions must be met before the engine will remote start: 

• Shift lever in PARK
• Doors closed
• Hood closed
• HAZARD switch off
• BRAKE switch inactive (brake pedal not pressed)
• Battery at an acceptable charge level
• FOB PANIC button not pressed
• System not disabled from previous remote start event
• Vehicle theft alarm not active
• Ignition in OFF state
• Suitable fuel level condition

Using the diagnostic scan tool, confirm that all relevant switches and operations are proper.

If all of the previous items checked OK, and the remote starting system will not operate. Refer to STARTING - NON-DTC BASED DIAGNOSTICS .