Gen 5

WARNING: This page is about a different car, the 2025 Jeep Compass. However, it is still accessible from the selected car via links, so may be relevant.

This procedure must be performed in the following cases:

Removing / Installing the radar sensor.
Warning light indicated the failure of the radar sensor Proximity.
Rear axle adjustments.
Removing / Installing the front end.

Confirm the tire pressures are proper before starting the calibration procedure.

Connect the diagnostic scan tool to the vehicle.
Navigate to the ACC module "ECU view".
Select the "Misc Functions" menu.
Select the "ACC DASM Drive Calibration" procedure and then comply with the instructions provided on the diagnostic scan tool.

NOTE: A Wi-Fi Mobile Hot Spot router is required for this procedure.