Service Reminder Indicator (Sri) Memory Check & Mileage

TRANSFER

NOTE: Perform SRI memory check only if referred here by diagnostic tests. Perform mileage transfer procedure only if PCM is being replaced.

When PCM is replaced, copy vehicle mileage from odometer to replacement PCM memory. Transfer of vehicle mileage will enable new PCM to operate SRI light properly.

1) Ensure ignition is off. Attach DRB-II to engine diagnostic connector. Engine diagnostic connector is located in engine compartment, near PCM on all models except Dakota. On Dakota, diagnostic connector is located in right rear corner of engine compartment, taped to harness. Turn ignition switch to RUN position.

2) Copyright information and diagnostic program version will appear on screen for a few seconds. After a few seconds DRB-II menu will appear. At FUEL/IGN MENU, press "5" (ADJUSTMENTS) key. Press ENTER key. At ADJUSTMENTS menu, press "4" (SRI MEMORY CHK) key. Press ENTER key. DRB-II display will read SRI MEMORY CHECK ARE YOU SURE? (ENTER TO CONTINUE).

3) Press ENTER key. DRB-II will display SRI MEMORY TEST WRITE TEST [-------] and, after a few seconds, IS INSTRUMENT PANEL MILEAGE BETWEEN XXXXX AND XXXXX? (PRESS YES OR NO). If vehicle mileage is within specification, SRI memory check is complete. Press YES key. If vehicle mileage is not within specification, go to next step.

4) Press NO key. DRB-II will display ENTER MILEAGE SHOWN ON INSTRUMENT PANEL (USE ENTER TO END) XXXXXXX. Enter vehicle mileage. DO NOT enter tenths. When correct vehicle mileage is entered, press ENTER key.

5) DRB-II will ask for verification of mileage entry. If mileage entry was accurate, press ENTER key. DRB-II will display SRI MEMORY CHECK COMPLETE. Vehicle must travel at least 8 miles for reset to occur.