Chime Test 2A - Chime Inoperative At All Times
NOTE:
Perform CHIME TEST 1A
before proceeding with this test. For connector terminal identification, refer to CONNECTOR IDENTIFICATION
. For wiring diagrams, refer to WIRING DIAGRAMS
. Perform, after each repair, VERIFICATION TEST VER-1A - VERIFICATION PROCEDURE
.
CAUTION:
Always turn ignition switch to OFF position prior to disconnecting any module connector.
Ensure all doors are closed. Turn ignition switch to ON position. Using scan tool, actuate chime test. If chime sounds, system is functional. If chime does not sound, replace Body Control Module (BCM). BCM is located with junction block under driver's side instrument panel. See Fig 1 .