Front & Rear Toe

The static toe position should be final adjustment made to vehicle during alignment procedure.

NOTE: When setting front and rear wheel static toe position, it is recommended to leave engine running during front wheel toe setting procedure.

Start engine and turn wheels both ways before straightening and centering steering wheel. Retain steering wheel with clamp. Remove clamp from steering gear boot attaching it to inner tie rod. Loosen inner to outer tie rod end jam nut. See Figure .
CAUTION: Do not twist inner tie rod to steering gear rubber boots during this adjustment.
Grasp inner tie rod at adjustment serration. See Figure . Rotate inner tie rod in direction required to obtain specified individual wheel toe position. Tighten inner tie rod to outer tie rod jam nut to specification. See TORQUE SPECIFICATIONS . Adjust steering gear to inner tie rod boots at inner tie rod so boots are not twisted. Then install steering gear boot to inner tie rod boot clamp at tie rod. Remove steering wheel clamp. Remove all alignment equipment from vehicle. Remove caster angle inclinometers from front or rear knuckles.