FixVault
Home › Dodge and Ram › 2004 › Durango 3.7 K › Repair and Diagnosis › Engine Performance › Ignition System › Ignition Control › Sensor-Camshaft Position › Installation › 3.7L V-6

3.7L V-6

  1. Clean out machined hole in cylinder head.
  2. Apply a small amount of engine oil to sensor o-ring.
  3. Install sensor into cylinder head with a slight rocking and twisting action.
    CAUTION: Before tightening sensor mounting bolt, be sure sensor is completely flush to cylinder head. If sensor is not flush, damage to sensor mounting tang may result.
  4. Install mounting bolt and tighten. Refer to SPECIFICATIONS - TORQUE - IGNITION .
  5. Connect electrical connector to sensor.
About FixVault