FixVault
Home › Dodge and Ram › 2004 › Durango 3.7 K › Repair and Diagnosis › External Pages › Different car › Section 59 (Speed Control) › Servo › Installation

Section 59 (Speed Control): Servo: Installation

WARNING: This page is about a different car, the 2003 Dodge Dakota. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position servo to mounting bracket.
  2. Align hole in cable connector with hole in servo pin. Install cable-to-servo retaining clip.
  3. Insert servo mounting studs through holes in servo mounting bracket.
  4. Install servo mounting nuts and tighten to 8.5 N.m (75 in. lbs.).
  5. Connect vacuum line at servo.
  6. Connect electrical connector at servo.
  7. Connect servo cable to throttle body. Refer to CABLE  .
  8. Connect negative battery cable to battery.
  9. Before starting engine, operate accelerator pedal to check for any binding.
About FixVault