FixVault
Home › Dodge and Ram › 2004 › SRT-4 › Repair and Diagnosis › External Pages › Different car › Section 24 (Electronic Control Modules) › Controller Antilock Brake › Installation

Controller Antilock Brake: Installation

WARNING: This page is about a different car, the 2004 Dodge SX and 2004 Dodge Neon. However, it is still accessible from the selected car via links, so may be relevant.
  1. Connect 24-way wiring connector to CAB and push in connector lock.
  2. Align CAB with HCU half of ICU, then slide CAB up over HCU valves. Install four CAB mounting screws (Figure). Tighten mounting screws to 2 N.m (17 in. lbs.) torque.
  3. Connect pump/motor connector (Figure).
  4. Lower vehicle.
  5. Connect battery negative cable.
  6. Connect DRBIII®to vehicle to initialize system. Check and clear any faults.
About FixVault