FixVault
Home › Dodge and Ram › 2004 › SX R/T › Repair and Diagnosis › External Pages › Different variant/trim › Section 1 (Electronic Control Modules) › Controller Antilock Brake › Installation

Controller Antilock Brake: Installation

WARNING: This page is about a different variant/trim than selected.
  1. Connect 24-way wiring connector to CAB and push in connector lock.
  2. Align CAB with HCU half of ICU, then slide CAB up over HCU valves. Install four CAB mounting screws (Figure). Tighten mounting screws to 2 N.m (17 in. lbs.) torque.
  3. Connect pump/motor connector (Figure).
  4. Lower vehicle.
  5. Connect battery negative cable.
  6. Connect DRBIII®to vehicle to initialize system. Check and clear any faults.
About FixVault